Batteries are capable of delivering high current if the output is shorted. Do
not allow any conductive instrument (screwdriver, etc.) to make contact
with both battery terminals simultaneously, see Fig. 50 above.
If additional assistance is required please contact our Customer Service
Department at:
Colorado Time Systems, llc.
Attn: Customer Service Department
1551 East 11th Street
Loveland, CO 80537
Toll Free U.S. and Canada: 800-287-0653 x256
Phone: 970-667-1000 x256
Slide the ON/OFF switch on the control board to the “OFF” position.
Plug the scoreboard power cord into an electrical outlet.
The battery will require at least eight hours to fully recharge.
Note: The display on the operator’s console window will show
“Lo b” (low battery) whenever the ON/OFF switch on the control
board is in the “OFF” position and does not indicate that the
battery is low.
Note: Remove all electrical power to scoreboard.
Slide the weathercover of the top line of your scoreboard to the left, to
expose the battery on its sheet metal holder.
Unplug the battery cable from the control board.
Remove the two Phillips screws and star washers, one securing the top left
of the sheet metal battery holder to the scoreboard frame and the other
screw and washer from the bottom right.
Rotate the battery holder counter-clockwise and remove from scoreboard.
Note: Be careful when rotating the battery holder not to dislodge
any digit segments. If this does occur, consult page 7-4 for digit
repair instructions.
CAUTION
To Charge the Battery
Step 1
Step 2
Step 3
To Replace the Battery
Step 1
Step 2
Step 3
Step 4
7-13
Comentarios a estos manuales