Directed Electronics 581XP Guía de instalación descargar pdf (Pagina 40)

2-9 2

IGNITION/ACCESSORY OUTPUT: This will allow the PINK/WHITE to be used as a 2

ignition or an

accessory.

2-10 ACCESSORY STATE DURING WAIT-TO-START: This will allow the programming of the accessory wire during

the wait-to-start period of a diesel motor. When ON the accessory comes on when the wait-to-start output is

activated and stays on, dropping out during crank and returning once the car has started. When OFF the acces-

sory will activate as a normal accessory.

2-11 2

STATUS OUTPUT: This status will activate 10 seconds after the car has started. It is intended to operate

the defogger circuit. The output can be programmed to a latched or a pulsed output. When programmed to the

latched output the status will only stay active for 10 minutes.

2-12 ANTI-GRIND ON/OFF: With the anti-grind On (default) the ground-when-armed output will be active during

remote start operation. If accessories such as a voice module or window module are added to the unit, it may be

necessary to program this feature off.

tach learning

To learn the tach signal:

1. Start the vehicle with the key.

2. Within 5 seconds, press and HOLD the Valet/Program switch.

3. The LED will light constant when the tach signal is learned.

4. Release the Program switch.

DRW-96

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 46 47

Sin comentarios

Directed Electronics 581XP Guía de instalación Pagina 40