Directed-electronics Automate 552 Manual de usuario descargar pdf (Pagina 17)

harness 2 (H2), 2-pin auxiliary plug

Connect this wire to the wire in the vehicle that sends the signal to turn on the WAIT-TO-START bulb in the dash-

board. In most diesels the wire is negative (ground turns on the bulb) and the GRAY/BLACK can be directly

connected to the wire in the vehicle. If the vehicle uses a positive wire (12V to turn on the bulb) a relay must

be used to change the polarity. (See Finding the Wires You Need section of this guide.) Here are some common

colors of this wire:

■ Chevrolet and GMC trucks: Light Blue or Dark Blue

■ Ford Trucks: Black/Pink

■ Dodge Ram Trucks: Orange/Black or Black/Orange

H2/1 GRAY/BLACK (-) diesel wait-to-start bulb input

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 41 42

Sin comentarios

Directed-electronics Automate 552 Manual de usuario Pagina 17