Directed Electronics SIR-WRS1 Especificaciones descargar pdf (Pagina 15)

Desktop Docking Station

Stiletto Universal Boombox

Operation

Battery Installation

Your Boombox can operate independently of AC power by

installing 8 “D” batteries. The batteries are bypassed auto-

matically whenever the supplied AC Adapter is plugged into

the DC 12V jack on the rear panel.

1 Turn the Boombox upside down to access the bat-

tery compartment.

2 Push the battery cover latches forward and ﬂip up

the battery compartment cover to the open position

3 Insert eight 8 “D” batteries observing battery polar-

ity as shown, then close the cover.

WARNING:

Do not store batteries in the Boombox for long periods of

time as they may leak and cause damage to the system.

' '



' '



' '



' '



BOTTOM VIEW

Front

Battery compartment

The diagram below shows correct polarity of installed bat-

teries based on the above view. This diagram can also be

found inside the battery compartment.

Once the Boombox antenna has been installed, the power connected, and the Stiletto radio docked according to the setup

and installation instructions, power on the Boombox by pressing the Power On/Off button on the top panel. The light on the

top panel of the Boombox should light blue to indicate the power is on. If the radio does not power on at the same time,

press the Power On/Off button on the upper left side of radio.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

Sin comentarios

Directed Electronics SIR-WRS1 Especificaciones Pagina 15