Directed Electronics AutoCommand 28624TN Guía de instalación descargar pdf (Pagina 37)

Step 7, Programming

Programming transmitters

Your system can learn up to 4 transmitters. The following proce-

dure will show you how to add additional transmitters or replace

old ones. Each transmitters can be programmed one button at a

time or you can use an auto learn procedure that learns the

intended factory configuration. Learning one button at a time is

generally only used when using one transmitters to control two

different cars. Being able to program functions to different chan-

nels on each transmitters prevents multiple cars from responding

simultaneously.

1. Turn the ignition ON

2. Press/release the momentary switch the same number of

times as the desired transmitter learn Step number, and

then Press/HOLD.

3. After Holding the momentary switch for 2 seconds the

LED will begin to flash to indicate of the accessed trans-

mitter learn Step.

4. Press the transmitter button that you want to control

the function assigned to that transmitter learns Step;

the Horn/Siren will emit a long chirp.

note! For transmitter learn Step #1, you must press

the “*” button on the transmitter, this will auto-

matically program the transmitter buttons to the

default function configuration. See the transmit-

ter button auto learn chart for the assignment

functions.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 78 79

Sin comentarios

Directed Electronics AutoCommand 28624TN Guía de instalación Pagina 37