Directed-electronics BOA 165B Manual de usuario descargar pdf (Pagina 14)

step 1

Ground Wire

The BLACK (H1/5) wire on the main 8-pin harness is ground.

This wire should be connected to a clean, paint-free area of metal

in the drivers kick panel area. First strip back a ¾-inch section of

the insulation off the BLACK wire and crimp a ring terminal

(not provided) to that wire. Locate a clean, paint-free metal

surface in the drivers kick panel. Using a self-tapping screw, drill

the screw with the ring terminal to the metal area. Once screwed

down, pull on the wire to ensure a good connection.

SELF-TAPPING

BOLT OR SCREW

RING

TERMINAL

GROUND

WIRE

NOTE: REMOVE ANY PAINT

BELOW RING CONNECTOR

DIA-591

note: More problems are attributed to poor ground con-

nections than any other cause. Take extra care to ensure

the ground is a clean metal-to-metal contact and secure.

➜

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 42 43

Sin comentarios

Directed-electronics BOA 165B Manual de usuario Pagina 14