Directed Electronics VS102 Especificaciones descargar pdf (Pagina 46)

Peripheral Interfacing Options with Vocollect Voice Appliances Page 38

1-Dec-2010 Version 4.0

Peripheral operation - LXE 88810 / LXE 8820

Motorola LS-3578-FX / LS-3578-ER Gun Scanners & Talkman T5 Series Page 38

Rev 1.0/jjd

Scanner initiating pairing to the Talkman

This method of pairing is useful it a scanner is to be picked up needs to be paired with a Talkman.

Each Talkman should be labeled with a code 128 barcode that contains the FNC3 code followed by a

capital “B” and unique Bluetooth MAC address of the Talkman.

FNC3 may be generated on a PC with a full keyboard and numeric pad. To generate it, hold the

ALT key down and press the four number numeric key sequence “0 1 7 9” on the numeric keypad. A

small ³ typically will appear to indicate its presence. Some barcode software packages have special

insertion keystrokes for FNC3.

The Bluetooth MAC address of the Talkman may be found on the rear of the Talkman near the belt

clip beginning with “BT:”.) The

It may be convenient to place this label on the rear of the Talkman on the opposite side of the

Bluetooth label where it will be protected from wear.

Using VoiceConsole, locate the specific terminal to be paired with the scanner.

View the detailed properties of the Talkman T5 series terminal and assure that Bluetooth is

enabled; if it is not, click on “Edit this device” and set “Bluetooth Enabled” to “enabled”

6. Select the “Pair this device with a peripheral” option

7. For “Pairing Type” select “Bluetooth Scanner”

8. For “Connection Mode” select “Device listens for peripheral connection”

9. Click “Pair with peripheral” to initiate pairing

10. Scan the barcode that was created and placed on the terminal in the initial step

The scanner should now pair with the Talkman.

Note that many of the above settings may be done via creating a specific device profile in

VoiceConsole. This is the recommended approach for production use.

Important – When finished using the Talkman and scanner for the day it is advisable to unpair the

Talkman from the scanner by pairing it with the base. Simply scan the barcode on the scanner base

to pair the scanner with its base.

The scanner may also be unpaired by scanning the “unpair” bar code:

Performing this last step makes the scanner quiescent and assures that the scanner does not

generate spurious Bluetooth RF that could potentially interfere with other radio transmissions

including 802.11/RF network traffic. This is unlikely a concern with a small number of scanners,

however the more units which are in service increases the potential for interference.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 55 56

Sin comentarios

Directed Electronics VS102 Especificaciones Pagina 46