Directed Electronics 554R Guía de instalación descargar pdf (Pagina 44)

vehicle, one for each user.

rraappiidd rreessuummee llooggiicc

This Directed system will store its current state to non-volatile

memory. If power is lost and then reconnected the system will

recall the stored state from memory. This means if the unit is in

Valet

Mode and the battery is disconnected for any reason, such

as servicing the car, when the battery is reconnected the unit will

still be in Valet

Mode. This applies to all states of the system

including arm, disarm, and Valet

Mode.

ppoowweerr ssaavveerr mmooddee

Your system will automatically enter Power Saver Mode while

armed or in Valet

Mode, after a period of time in which no

operation has been performed. This lowers the current draw on

the vehicle's battery. Power Saver Mode takes over under the

following conditions:

➤ Power Saver when the system is armed: After the system has

been armed for 24 hours the LED will flash at half its

normal rate, decreasing the system's current draw.

note: Owner Recognition cannot be programmed with-

out a Bitwriter and the necessary software. Check with

your dealer for more information.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 52 53

Sin comentarios

Directed Electronics 554R Guía de instalación Pagina 44