Directed Electronics AUTOMATE 210D - OWNERS Manual de instrucciones descargar pdf (Pagina 21)

To disarm/disable the system:

1. Turn the ignition to the ON position.

2. Press and release the control center button the preset number of

times (one to ﬁve times) within15 seconds (the factory default set-

ting is 1 press). After ﬁve seconds, the sys tem will disarm/disable.

If the system does not disarm/disable, you may have waited too

long. Start over by turning the ignition off and on.

Number of Presses_____________________________________

Important: The control center button can be programmed to

respond to 1-5 presses for the disarm/disable function. You

must check with the installer to verify the programming for your

individual unit.

Valet mode

You can prevent your system from automatically arming/locking and

trig ger ing by using Valet Mode. This is very useful when washing the

ve hi cle or having it serviced. In Valet Mode, the system/starter kill will

not arm/enable, even with the remote control, but all convenience func-

tions (door locks, trunk re lease, etc.) will continue to work nor mal ly.

To enter or exit Valet Mode:

1. Turn the ignition on.

2. Turn the ignition off.

3. Press and release the control center button within 10 seconds.

To enter or exit Valet Mode using the remote control:

1. Open any vehicle door.

2. Press

3. Press

and then press again.

The status LED lights solidly if you are en ter ing Valet Mode, and goes

off when you exit Valet Mode.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 35 36

Sin comentarios

Directed Electronics AUTOMATE 210D - OWNERS Manual de instrucciones Pagina 21