
21
© 2010 Directed Electronics. All rights reserved.
To remote start the vehicle:
• Press
on the remote control once.
The parking lights flash to confirm that the vehicle will attempt to
start. With gas vehicles the engine starts 4 seconds after the park-
ing lights flash. With diesel vehicles the engine starts when the
WAIT-TO-START indicator on the dashboard goes out or the pro-
grammed delay has ended.
Once the vehicle has started, it runs for the pre- pro gram med pe-
riod of time (either 12, 24, or 60 minutes; See Programming Op-
tions section) or until a shutdown input is trig gered.
Warning! It is unsafe to operate a vehicle’s motor in
a garage or other closed off area. Breathing the ex-
haust from the vehicle is hazardous to your health.
Never activate the remote start in an enclosed space.
When you are ready to drive the vehicle:
1. Insert the ignition key and turn it to the On position.
2. Press the brake pedal.
Note: If the brake pedal is pressed before the key is in the ON position,
the engine will shut down.
While the vehicle is running during remote start operation, the system
monitors the ve hi cle and automatically shuts down the engine if the
system receives any of the following:
• The brake pedal is pressed
• The hood is opened
• The shutdown toggle switch is put into the Off position.
• Runtime (12,24, or 60 minutes) expires
• Remote control button
is pressed once.
Comentarios a estos manuales