Directed Electronics RSIII Guía de instalación descargar pdf (Pagina 34)

NOTE: A dim or pulsing LED when learning tach means the unit has not learned the tach signal.

Test all connections, and if good, relocate the tach input wire and continue with tach learning

procedure.

Shutdown Diagnostics

The unit has the ability to report the cause of the last shutdown of the remote start system.

TToo eenntteerr ddiiaaggnnoossttiicc mmooddee::

1. Turn the ignition off.

2. Press and hold the Valet/program switch.

3. Turn the ignition on then off again.

4. Release the Valet/program switch.

5. Press and release the Valet/program switch.

The LED will now report the last system shutdown by flashing for one minute in the below grouped

patterns; the LED will stop flashing when the ignition is turned on.

2002

Directed Electronics, Inc.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 43 44

Sin comentarios

Directed Electronics RSIII Guía de instalación Pagina 34