Directed Electronics RSIII Guía de instalación descargar pdf (Pagina 8)

2002

Directed Electronics, Inc.

H1/2 WHITE (+/-) Selectable Light Flash Output

As shipped, this wire should be connected to the (+) parking light wire. If the light flash polarity

jumper is moved to the (-) position (see the Programming Jumper section of this guide), this wire

supplies a (-) 200 mA output. This is available for driving (-) light control wires in Toyota, Lexus,

BMW, some Mitsubishi, some Mazda, and other models.

NOTE: For parking light systems that draw 10 amps or more, the jumper must be switched to a

(-) light flash output. (See the Programming Jumpers section of this guide.) P/N 8617 or a standard

automotive SPDT relay must be used on the H1/2 light flash output wire.

IMPORTANT! DO NOT connect this wire to a negative vehicle light flash wire before

changing the programming jumper to the negative polarity position or damage to

vehicle light circuit may occur.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 43 44

Sin comentarios

Directed Electronics RSIII Guía de instalación Pagina 8