Directed Electronics Ready Remote Guía de instalación descargar pdf (Pagina 18)

Pit Stop Mode

Vehicle Takeover with Get In and Go*

** Your aftermarket remote may differ from the model shown in the illustrations.

* Get In and Go connections required.

* Your aftermarket remote may differ from the model shown in the illustrations.

The Pit Stop Mode feature is practical when you need to stop and run an errand,

but wish to keep the engine running.

Get In and Go

Get In and Go is designed to provide users with easy takeover when

entering their Push-to-Start (PTS) equipped vehicle, once it has been

remote started.

Typically, users would have to remote start their vehicle, then get inside and press

the vehicle start button to perform a takeover. There is therefore a physical action

required to drive away. With Get In and Go technology, you simply remote start the

vehicle, unlock the doors, get in and go... Nothing to do but put the gear in drive and

enjoy your vehicle.

This unique feature monitors a variety of parameters such as the key fob, vehicle

speed sensor and door sensor, in order to perform takeover securily.

Press the remote start button on the transmitter to

start the vehicle.**

Press the brake pedal, put the car

in gear and drive off.

Enter the vehicle, while making sure the

key fob is inside with you.

Press the Unlock button on the key

fob or aftermarket remote.**

Ready to

drive off

Press

remote start

button**

Press Unlock

button on

either remote**

Enter vehicle

with key fob

Stop the vehicle in a safe parking spot

and put the gear in Park (P).

Stop & put vehicle in Park (P)

Press

remote start

button*

Exit vehicle with

Smart Key

Note: We recommend that you always lock the doors

of your vehicle when leaving it unattended.

It is now safe to leave the engine running and exit the

vehicle with the Smart Key in hand.

Press the button to remote start the vehicle.*

The parking lights will flash once to indicate the

vehicle is now in Pit Stop Mode.

Parking Light Error Codes

The parking lights on your vehicle will flash a specific number of times 3 seconds

following an unscheduled shutdown or failure to start. Each flashing pattern is

described below.

Flashes Diagnostic

1 Runtime expired.

2 Over-rev shutdown.

3 Low/No RPM.

4 Transmitter shutdown.

5 Brake shutdown.

6 Hood shutdown/Remote start safety override switch is ON*.

7 Remote start safety override switch is ON*.

* If the vehicle hood status is supported through data, safety override switch input

will report 7 flashes.

Quick Reference Guide

DBALL-NISS3HT Remote Start Ready (RSR) Installation

1 2 ... 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios

Directed Electronics Ready Remote Guía de instalación Pagina 18

Comentarios a estos manuales

Relacionado con productos y manuales para Arrancadores remotos Directed Electronics Ready Remote