Directed Electronics Valet 561T Guía de instalación descargar pdf (Pagina 13)

1133

NNOOTTEE::

When the activation pulse count can be programmed to 1, 2, or 3 pulses when changed it

will affect both activation inputs; the White/Blue wire and the remote control activation.

Connect this wire to the wire in the vehicle that sends the signal to turn on the WAIT-TO-START bulb in the dash-

board. In most diesels the wire is negative (ground turns on the bulb) and the GRAY/BLACK can be directly

connected to the wire in the vehicle. If the vehicle uses a positive wire (12V to turn on the bulb) a relay must

be used to change the polarity. (See

Finding the Wires You Need

section for testing procedures.) Here are some

common colors of this wire:

■ Chevrolet and GMC trucks: Light Blue or Dark Blue

■ Ford Trucks: Black/Pink

■ Dodge Ram Trucks: Orange/Black or Black/Orange

NNOOTTEE!!

A 1-amp diode must be installed in line on the factory wire between the wait-to-start indi-

cator and the ECM. (See the following diagram for details.)

HH11//55 GGRRAAYY//BBLLAACCKK ((--)) ddiieesseell wwaaiitt--ttoo--ssttaarrtt bbuullbb iinnppuutt

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 38 39

Sin comentarios

Directed Electronics Valet 561T Guía de instalación Pagina 13