Directed Electronics Valet 561T Guía de instalación descargar pdf (Pagina 27)

2277

TTrraannssmmiitt..

While

HHOOLLDDIINNGG

the Program switch, press the button on the transmitter that you

would like to control the selected receiver channel.

RReelleeaassee..

Once the code is learned, the Program switch can be released.

You can advance from programming one channel to another by releasing the Program switch and tapping it to

advance steps and then holding it. For instance: You have programmed Channel One and you want to program

Channel Two. Release the Program switch. Press it one time and release it to advance from Channel One to

Channel Two. Now, press and

HHOOLLDD

the Program switch. The LED will flash two times. As before, do not release

it.

If you want to program Channel Three after programming Channel One, release the Program switch, press it twice

and release it to advance to Channel Three. Then press it once more and

HHOOLLDD

it. The LED will flash three times

to confirm it is ready to receive the code from the transmitter.

LLeeaarrnn RRoouuttiinnee wwiillll bbee eexxiitteedd iiff::

■ Ignition is turned off.

■ Program switch is pressed too many times.

■ More than 25 seconds elapses between programming steps.

CCHHAANNNNEELL NNUUMMBBEERR FFUUNNCCTTIIOONN

1 Auto-Learn*

2 Lock/Unlock

3 Channel 2 output

4 Remote Start

5 Turbo/Short Run

6 Timer Mode

7 Defogger Control

8 Delete all Transmitters**

**NNOOTTEE::

For Auto Learn Configurations, see Transmitter Configurations section of this

guide.

****NNOOTTEE::

If any button from a known transmitter is programmed to Channel 8, all

transmitters will be erased from memory and will revert to the default feature set-

tings. This is useful in cases where the customer's transmitters are lost or stolen.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 38 39

Sin comentarios

Directed Electronics Valet 561T Guía de instalación Pagina 27