Directed Electronics Valet 561T Guía de instalación descargar pdf (Pagina 34)

3344

The LED will stop flashing when the ignition is turned on.

rreeaarr ddeeffooggggeerr ccoonnttrrooll

The rear defogger output can be remotely turned on/off any time using the remote control. The default setting

OONN

To turn the rear defogger output OFF:

1. Press & release the / and and buttons of the remote control.

2. The parking lights will flash 2-times.

3. The rear defogger output will no longer activate when the vehicle is remote started.

NNOOTTEE::

If the remote start is On the lights will turn off then flash 2-times before returning to

their normal output and the defogger output, if active, will cease.

To turn the rear defogger output ON:

1. Press & release the / and and buttons of the remote control.

2. The parking lights will flash 3-times.

3. The rear defogger output will once again activate when the vehicle is remote started.

NNOOTTEE::

If the remote start is On the lights will turn off then flash 3-times before returning to

their normal output and the defogger output will activate as programmed.

LLEEDD SSHHUUTTDDOOWWNN

FFLLAASSHHEESS MMOODDEE

One System timed out

Two Over-rev shutdown

Three Low or no RPM

Four Transmitter Shutdown (or optional push-button)

Six (+/-) Shutdown

Seven (-) Neutral safety shutdown (H2/6 BLACK/WHITE)

Eight Wait-to-start timed out

1 2 ... 29 30 31 32 33 34 35 36 37 38 39

Sin comentarios

Directed Electronics Valet 561T Guía de instalación Pagina 34