Directed Electronics VS102 Guía de usuario descargar pdf (Pagina 23)

Chapter 2: Installation

Pole Mount

Note: This pole mount does not meet the IEC 60945, section 8.7 for

vibration.

Keep the following in mind when using a pole mount:

• Thread type of the four mounting holes is 1" thread, 0.9" depth

• Hand tighten until snug (do not

overtighten)

• Use the set screws on the long sides of the base (see middle

drawing in Figure 2-6 on page 13) to secure the V102 in place (3/16"

Allen wrench not included)

Overtightening may damage the system. This is not covered

under warranty.

Before pole mounting the V102

• Decide if you need the roll measurement. If you need roll

measurement, the V102 will need to be installed perpendicular to

the vessel axis. If it you do not need roll measurement, install the

V102 parallel with the vessel’s axis.

• Choose a location that meets the mounting location requirements.

• Mark and drill the mounting holes as necessary for the threaded

pole.

• Attach the power/data cable to the cable clamp and attach the clamp

to the bottom of the V102 using the screw and washer. Do not fully

tighten the screw so you can adjust the cable as necessary when

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 59 60

Sin comentarios

Directed Electronics VS102 Guía de usuario Pagina 23