Directed Electronics Matrix 1 Guía de instalación descargar pdf (Pagina 10)

H1/11 RED (+)12V constant power input

Before connecting this wire, remove the supplied fuse. Connect to the battery

positive terminal or the constant 12V supply to the ignition switch.

NOTE: Always use a fuse within 12 inches of the point you obtain (+)12V.

Do not use the 15 amp fuse in the harness for this purpose. This fuse protects

the module itself.

H1/12 RED/WHITE 200 mA (-) channel 2 output

When the system receives the code controlling channel 2 for longer than 1.5

seconds, the RED/WHITE will supply an output as long as the transmission

continues. This is often used to operate a trunk/hatch release or other relay/

driven function.

IMPORTANT! Never use this wire to drive anything but a relay

or a low-current input! The transistorized output can only supply

200 mA of current. Connecting directly to a solenoid, motor, or

other high-current device will cause it to fail

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Sin comentarios

Directed Electronics Matrix 1 Guía de instalación Pagina 10