Directed Electronics Matrix 1 Guía de instalación descargar pdf (Pagina 9)

grounded at the same location.

H1/9 YELLOW (+) ignition input

Connect this wire to the (+) 12 volts ignition wire. This wire is pre-wired to

the starter kill relay and must show (+) 12 volts with the key in RUN position

and during cranking. Take great care that this wire cannot be shorted to the

chassis at any point.

\\\\\\\

H1/10 BROWN (+) siren output

Connect this to the RED wire of the Revenger® siren. Connect the BLACK

wire of the siren to (-) chassis ground, preferably at the same point you connect

the control module’s BLACK ground wire.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 39 40

Sin comentarios

Directed Electronics Matrix 1 Guía de instalación Pagina 9