Directed Electronics AutoCommand 25522 Manual de instalación descargar pdf (Pagina 14)

2005 Directed Electronics, Inc.

21. Special Programming Options

The AutoCommand

unit has 8 special options and features. You will not need

to use these special options in most situations. The factory settings will oper-

ate most vehicles. You must turn the On/Off control switch to the “OFF”

position to program any features. Note that when turning off this control

switch, the red LED will flash a few times, giving the diagnostic code described

in Section 20. Wait a few seconds for it to finish before programming your new

Options.

# Factory Setting (2 flashes) Option (1 flash)

1 “No-Tach” Tach Mode

2 10 min. run time 15 min. run time

3 Normal Crank Extended Crank

4 Normal Crank Super Crank

5 Normal Voltage Metering Ignore Voltage Metering

6 Gasoline vehicles Diesel vehicles

7 “Enable” feature No “Enable”

8 Normal Trigger Double Pulse Trigger

#1 sets the starting method. The factory setting uses “No-Tach” start-

ing. If you wish to use the tach to start, follow the instructions in 12A.

#2 is for the choice of run times.

#3 will add 50% more crank time to “No-Tach” starting.

#4 adds 100% more crank time. This is necessary on many deisel a n d

hard to start vehicles. Options #3 and #4 can be added together for

even more cranking time.

#5 is used in the “No-Tach” starting method for some diesel vehicles.

#6 option must be activated when installing on a diesel vehicle.

#7 cancels the Enable mode safety feature. The Enable mode requires

that the driver toggle the ON/OFF control switch “OFF” then “ON” in

order to “enable” the vehicle for AutoCommand

control. This feature

guards against undesired starting of the vehicle by remote control.

#8 Normal Trigger will start and stop the AutoCommand with a single

quick ground pulse to the Remote Input wire of Step 13. Double Pulse

Trigger mode will not activate the AutoCommand until it has seen two

pulses within 3 seconds time. Thus if you hook the Remote Input wire

up to the Door Lock wire of your keyless entry module -- you can lock

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Sin comentarios

Directed Electronics AutoCommand 25522 Manual de instalación Pagina 14