Directed Electronics AutoCommand 25622 Manual de instalación descargar pdf (Pagina 10)

2005 Directed Electronics, Inc.

USER TIPS AND NOTES

The Remote Car Starter must be “enabled” each time the driver has finished driving and taken out

the key in order for the unit to start the vehicle remotely.

After the key has been removed, you must turn

OFF the control switch and then turn it back ON again while no key is in the ignition. This “control switch” or “set

switch” prevents unauthorized starting of the car by someone unfamiliar with the system who may be using the

vehicle. If you forget to set the switch, it may also be activated by pushing the transmitter and holding the button

down for ten seconds. To eliminate the need for this, see Option #7.

The AutoCommand

Remote Car Starter will turn the car off if the driver does not insert and turn the key within

10 or 15 minutes. After the AutoCommand

Remote Car Starter has started your car, simply put in the key and

turn it to the “run” or “on” ignition position (not the crank position) to drive away.

The AutoCommand

Remote Car Starter has numerous safety and security features that make it difficult to steal

your car without the key being in the ignition. Putting your car in gear, tapping the brake pedal or opening the hood

will turn the unit off unless your key is in the ignition and turned to the “run” or “on” position.

If all features are hooked up, your transmitter will function as follows:

Button 1: Do not push for your first ‘main’ vehicle

Once: To operate vehicle #2 - then any of the 4 buttons (LED flashes red

and green)

Again: For vehicle #3 - then any of the 4 buttons (LED flashes red)

Again: For vehicle #4 - then any of the 4 buttons (LED flashes green)

Button 2:

Once: Start the car with all accessories left on

Again: Stop the car

Button 3: Once: Turn on headlights for 30 seconds

Again: Turn off headlights

Hold down for 4 seconds for PANIC mode (45 seconds long)

Button 4: Lock the doors / arm the alarm

Button 5: Unlock the doors / disarm alarm (if you get 4 chirps – that means the

alarm was triggered while you were away)

Hold down for 4 seconds for Trunk

The LED on the transmitter will display 3 different colors - Red for button #2, Yellow for button #3, and Green for

buttons #4 and #5. The transmitter is powered by a long life lithium battery (CR 2032 style). The transmitter and

receiver module are FCC and DOC approved.

Alarm Disarm without transmitter:

If the doors are locked and the alarm is set and you’ve lost your

transmitter, you can disable the alarm. Here is how: Enter the vehicle (alarm will sound) and insert the key and

turn it to the ‘run’ position (the position where the dash lights come on). Turn the On/Off switch off and on 4 times

in a row to disable the alarm.

Valet Mode:

Turning the Control switch off puts you in Valet Mode. In Valet Mode the Remote Car Starter and

the alarm will not function. This lets you turn off the car starter when having the vehicle serviced. The only

functions that work in Valet Mode are the keyless entry, lights and panic. The red LED dash light will flash twice

every few seconds when in Valet Mode.

The Quick Stop Option

™

: You can leave the car running and take the key with you for a quick visit to a store.

With the car running, push the Start button on the keychain transmitter just before pulling out the key. The car will

run for 10 minutes or until you tap the brake or put the car in gear.

The Cold Start Option

™

: This automatically starts and runs the car for the preset run time (10 or 15 minutes) if

the temperature drops below 0

F or if the battery voltage drops below 11 volts. Tapping the brake at any time after

programming disables this feature. Here is how to set this feature: Hold the Start button down while the vehicle

starts, runs, turns off and the lights begin to flash 5 times. Release the transmitter button. You have set the Cold

Start Option™.

v5.3

limited lifetime consumer warranty

Directed Electronics, Inc. (hereinafter “Directed”) promises to the original purchaser to repair or replace

with a comparable reconditioned Directed remote start keyless entry unit if this Directed remote start

keyless entry unit (hereinafter “Unit”), excluding without limitation, any remote transmitters or associated

accessories, proves defective in materials or workmanship under normal use for the life of the vehicle

which the Unit is originally installed. During this period, so long as the Unit remained installed in the

original vehicle, Directed will at its option, repair or replace this Unit if it is proved defective in workmanship

or material PROVIDED the Unit is returned to Directed’s warranty department at One Viper Way,

Vista, CA 92081, along with $20 postage and handling fee, a bill of sale or other dated proof of purchase

bearing the following information: Date of purchase, name and location of the merchant who sold the

Unit, and product description. This warranty does not cover labor costs for the removal or reinstallation

of the Unit. This warranty is non-transferable and does not apply to any Unit that has been modified or

used in a manner contrary to its intended purpose, and this warranty does not cover damage to any Unit

caused by installation or removal of the Unit. This warranty is void if the Unit has been damaged by

accident or unreasonable use, neglect, improper service or other causes not arising out of defects in

materials or workmanship. Directed makes no warranty against theft of a vehicle or its contents.

THE FOREGOING WARRANTY IS THE EXCLUSIVE PRODUCT WARRANTY, OTHERWISE,

ALL WARRANTIES INCLUDING BUT NOT LIMITED TO EXPRESS WARRANTY, IMPLIED

WARRANTY, WARRANTY OF MERCHANTABILITY, OR FITNESS FOR A PARTICULAR

PURPOSE ARE EXPRESSLY EXCLUDED AND DISCLAIMED TO THE MAXIMUM EXTENT

ALLOWED BY LAW, AND DIRECTED NEITHER ASSUMES NOR AUTHORIZES ANY PERSON

TO ASSUME FOR IT ANY LIABILITY IN CONNECTION WITH THE SALE OF THE PRODUCT.

DIRECTED HAS ABSOLUTELY NO LIABILITY FOR ANY AND ALL ACTS OF THIRD PARTIES

INCLUDING ITS AUTHORIZED DEALERS OR INSTALLERS. SOME STATES DO NOT ALLOW

THE LIMITATION ON HOW LONG AN IMPLIED WARRANTY LASTS, SO THE ABOVE

LIMITATION MAY NOT APPLY TO YOU.

LIMITATION OF DAMAGES AND LIABILITY. CONSUMER’S REMEDY IS LIMITED TO REPAIR

OR REPLACEMENT OF THE UNIT, AND IN NO EVENT SHALL DIRECTED’S LIABILITY

EXCEED THE PURCHASE PRICE OF THE UNIT. IN ANY EVENT, DIRECTED SHALL NOT BE

LIABLE FOR ANY DAMAGES INCLUDING, BUT NOT LIMITED TO, ANY DIRECT, INDIRECT,

INCIDENTAL, SPECIAL, PUNITIVE OR CONSEQUENTIAL DAMAGES, LOST PROFITS, LOST

SAVINGS, OR, TO THE EXTENT ALLOWED BY APPLICABLE LAW, DAMAGES RESULTING

FROM DEATH OR INJURY ARISING OUT OF

OR IN CONNECTION WITH THE

INSTALLATION, USE, IMPROPER USE, OR INABILITY TO USE, THE PRODUCT, EVEN IF

THE PARTY HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES

DO NOT ALLOW THE EXCLUSION OF LIMITATION OF INCIDENTAL OR

CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATIONS OR EXCLUSION MAY NOT

APPLY TO YOU. THE CONSUMER AGREES AND CONSENTS THAT ALL DISPUTES BETWEEN

THE CONSUMER AND DIRECTED SHALL BE RESOLVED IN ACCORDANCE WITH

CALIFORNIA LAWS IN SAN DIEGO COUNTY, CALIFORNIA.

IMPORTANT NOTE:

This product warranty is automatically void if its date code or serial number is defaced,

missing, or altered.

Make sure you have all of the following information from your dealer:

A clear copy of the sales receipt, showing the following:

➤

Date of purchase

➤ Authorized dealer’s company name and address

➤ Item number

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Comentarios a estos manuales

Sin comentarios

Directed Electronics AutoCommand 25622 Manual de instalación Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Arrancadores remotos Directed Electronics AutoCommand 25622