Directed Electronics Automate 210D Instrucciones de operaciones descargar pdf (Pagina 136)

Counting with Additional Requirements

Changing the Reference Sample Quantity

You can change the reference sample quantity as required:

– Enter the reference sample quantity (piece count) using the numeric keys and store

it with F identified by “STO REF”

– Change it in the parameter mode

To select the parameter mode: – Hold down i for more than 2 seconds

To change the setting: – Use f identified by “^”

If you enter a wrong number, press c to clear it

To store the reference quantity

– temporarily until you turn off

the power: – briefly press STO - F

– permanently after you turn off

the power (in the non-volatile

memory): – press STO - F for more than 2 seconds

This setting is not cancelled by the reset code 9 – – 1°!

Reference Sample Quantity

Changing the reference sample quantity Code

No change 2 3 1

In cycles: 5,10, 20, 50, 100, 5,10, ... 2 3 2*

In increments of one 2 3 3

Storage Parameter for the Reference Sample Weight

(Code only for models MC 210 S (-0CE), MC 210 P (-0CE), MC 410 S (-0CE))

The weight is stored Code

with full accuracy according to the internal resolution 3 5 1

according to the display accuracy 3 5 2*

* = factory setting

3–58

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 187 188

Sin comentarios

Directed Electronics Automate 210D Instrucciones de operaciones Pagina 136