Directed Electronics Automate 210D Instrucciones de operaciones descargar pdf (Pagina 69)

Fully Automatic Draft Shield Function

You can define the fully automatic draft shield function to meet the most diverse

requirements. After you have pressed a function key (or after a control command

has been received – see part 4, “Interface Description”), the draft shield will close

automatically and the balance will then perform the particular function activated

by the key. If code 8 8 2 or 8 8 3 is set, the draft shield will open once the

function selected has been performed. In addition, when codes 8 8 2 through

8 8 5 are set, the draft shield closes automatically if the balance has not been

used for more than one minute.

To be on the safe side for automatic operation of the balance with a robot, you

should turn off the fully automatic draft shield function (code 8 8 1).

The draft shield status should always be polled for operation with a robot

(see part 4, “Interface Description”).

The draft shield operates automatically for the following functions:

– powering on the balance (e key)

– taring once the balance has stabilized (t key)

– printing on request after stability (p key)

– starting all calibration functions (f key)

– using the tare memory once the balance has stabilized (f key) –

see also part 3, “Application Programs”

– storing weights during differential weighing and backweighing, weighing in

percent and counting (F key) – see also part 3, “Application Programs”

– storing weights during over/under checkweighing (f key) –

see also part 3, “Application Programs”

2–23

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 187 188

Sin comentarios

Directed Electronics Automate 210D Instrucciones de operaciones Pagina 69