Directed Electronics Automate 210D Instrucciones de operaciones descargar pdf (Pagina 35)

The balance offers you various calibration and

linearization functions.

You can interrupt any calibration or linearization

procedure by pressing the c key (32).

In the fully automatic mode, the draft shield closes

after the f or the t key has been pressed.

Important Note:

! During calibration or linearization, you must observe

the following:

– Unload the weighing pan

– Do not disconnect the balance from AC power

– Do not unplug the connecting cable

Important Note to Users of Verified Balances

Approved for Use as Legal Measuring Instruments:

Internal Calibration

CAL Function Using the f Key:

Unload the pan and tare (if necessary, close the

draft shield).

When the balance shows a zero readout, press the

f key (21).

“C” will now be displayed. The built-in calibration

weights are internally applied by servomotor and

removed at the end of calibration.

If external interference affects the calibration

procedure, you may obtain a brief display of the error

message “Err 02.”

In this case, tare and then press the f key again

when a zero readout appears.

An acoustic signal indicates the end of calibration.

Before using your balance as a legal measuring

instrument, you must carry out the internal calibration

function at the place of installation (see below).

1–31

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 187 188

Sin comentarios

Directed Electronics Automate 210D Instrucciones de operaciones Pagina 35