Directed Electronics Viper ESP 540 Guía de instalación descargar pdf (Pagina 104)

Solderless terminal crimpers

Drill bit set

Cordless power drill

Phillips head screwdriver

Torx driver set

Work light

deciding on component location

control module

Never put the control module in the engine compartment!

The first step in hot-wiring a vehicle is removing the driver's side underdash panel to

access the starter and ignition wires. If the control module is placed just behind the

driver's side dash it can easily be disconnected.

When locating the control module, try to find a secure location that will not require

you to extend the harnesses’ wires (they are 1.5 meters long). Keep it away from the

heater core (or any other heat sources) and any obvious leaks.

Some good control module locations: Above the glove box, inside the center console,

above the underdash fuse box, above the radio, etc.

N427V_05-05.qxd 6/8/2005 12:37 PM Page 5

25-Mar-10

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 177 178

Sin comentarios

Directed Electronics Viper ESP 540 Guía de instalación Pagina 104