Directed Electronics Viper ESP 540 Guía de instalación descargar pdf (Pagina 23)

H1/9 YELLOW (+) ignition input: Connect this wire to the (+)12V igni-

tion wire. This wire must show (+)12V with the key in Run position and

during cranking. Take care to insure that this wire cannot be shorted to

the vehicle chassis at any point.

H1/10 BROWN (+) siren output: Connect this to the RED wire of the

siren. Connect the BLACK wire of the siren to (-) chassis ground, prefer-

ably at the same point as the control module’s BLACK ground wire.

H1/11 RED (+)12V constant power input: Before connecting this wire,

remove the supplied fuse. Connect to the battery positive terminal or the

constant 12V supply to the ignition switch.

Always use a fuse within 12 inches of the point you obtain (+)12V. Do

not use the 15A fuse in the harness for this purpose. This fuse protects

the module itself.

H1/12 RED/WHITE (-) 200mA auxiliary channel/delayed accessory

output: If programmed for an auxiliary output, this wire will provide a

(-) pulse when the lock button on the factory transmitter is pressed twice

within three seconds. This output can be used to control optional acces-

sories. If programmed for delayed accessory output, this wire will pro-

N3001L_2009-04print.qxd 5/12/2009 11:14 AM Page 17

25-Mar-10

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 177 178

Sin comentarios

Directed Electronics Viper ESP 540 Guía de instalación Pagina 23