Directed Electronics Viper ESP 540 Guía de instalación descargar pdf (Pagina 24)

vide (-) ground when the ignition is turned off and will continue to out-

put (-) ground until a door is opened then closed. This can be used to

energize the accessory circuit in the vehicle to keep the radio and other

accessories on after the ignition is turned off.

IImmppoorrttaanntt!!

Never use this wire to drive anything but a relay or

a low-current input! This transistorized output can only supply

(-) 200 mA, and connecting directly to a solenoid, motor, or

other high-current device will cause the module to fail.

Sensors and other triggers can be bypassed if this output is used to open

the vehicle trunk while the alarm is armed. See H2/5 Gray zone shunt-

ing for programming and connection descriptions.

Auxiliary harness wire connection

guide

Auxiliary harness wiring diagram

YELLOW/BLACK Light Flash Monitor Input

VIOLET/BLACK No Function

GRAY (+) Trunk Release/Sensor Shunt Input

BLUE Disarm Input

RED Disarm Defeat Input

GREEN Arm Input

BROWN (-) Horn Honk Output

H2/1

H2/2

H2/3

H2/4

H2/5

H2/6

H2/7

N3001L_2009-04print.qxd 5/12/2009 11:14 AM Page 18

25-Mar-10

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 177 178

Sin comentarios

Directed Electronics Viper ESP 540 Guía de instalación Pagina 24