Directed Electronics Viper ESP 540 Guía de instalación descargar pdf (Pagina 126)

long term event history

The control module will store the last 2 triggers in memory that are not erased when

the ignition is turned on. This can be helpful for trouble shooting false alarm reports.

To access the event history use the following procedure.

1. Turn the ignition switch off and press and hold the Valet

button.

2. While holding the Valet

button turn the ignition On.

3. Release the Valet

button.

4. Within 5-seconds, press and release the Valet

button.

The LED will flash in groups indicating the last two zones reported triggered. For

example, if zone 2 and 3 were the last two zones to be triggered, the LED will flash

two times followed by a pause and then flash three times followed by a pause.

NNOOTTEE::

The Warn Away

response does not report on the LED.

The Long Term Event History will exit if the ignition is turned off or there is no activity

for 60-seconds.

rapid resume logic

The current state of the alarm will be stored in non-volatile memory. If power is lost

and then reconnected, the system will recall the stored state from memory (arm, dis-

arm, and Valet

mode).

N427V_05-05.qxd 6/8/2005 12:37 PM Page 27

25-Mar-10

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 177 178

Sin comentarios

Directed Electronics Viper ESP 540 Guía de instalación Pagina 126