Directed Electronics Viper ESP 540 Guía de instalación descargar pdf (Pagina 43)

Troubleshooting

Starter kill does not work:

Is the correct starter wire being interrupted? If the car starts when the

starter kill relay is completely disconnected, the wrong starter wire has

been cut and interrupted.

• Is the yellow wire connected to “true” ignition? Make sure this wire

is connected to a wire that has power in the run and start positions.

• The starter kill goes active 1 minute after arming the alarm. Make

sure you wait that time period before attempting to test.

The Valet switch does not work.

• Is it plugged into the correct socket? See the Valet Switch section of

this guide.

• Is the H1/9 YELLOW wire properly connected? See Primary

Harness (H1) Wire Connection Guide section of this guide.

• If the mounting of the switch is a tight fit it can cause the switch not

to work properly. Make sure the hole size is drilled with a 5/16 drill

bit.

Status LED does not work.

• Is the LED plugged into the small white port on the side of the con-

trol unit? See LED and Valet Switch section of this guide.

N3001L_2009-04print.qxd 5/12/2009 11:14 AM Page 37

25-Mar-10

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 177 178

Sin comentarios

Directed Electronics Viper ESP 540 Guía de instalación Pagina 43