Directed Electronics Viper ESP 540 Guía de instalación descargar pdf (Pagina 36)

Long term event history

The control module will store the last 2 triggers in memory that are not

erased when the ignition is turned on. This can be helpful for trouble

shooting false alarm reports. To access the event history use the follow-

ing procedure.

1. With the ignition switch in the off position press and hold the Valet

switch.

2. While holding the Valet switch turn the ignition On.

3. Release the Valet switch.

4. Within 5-seconds, press and release the Valet switch.

The LED will flash in groups indicating the last two zones triggered. For

example, if zone 2 and 3 were the last two zones to be triggered, the

LED will flash two times followed by a pause and then flash three times

followed by a pause.

NNoottee::

The Warn Away

response does not report on the LED.

The Long Term Event History will exit if the ignition is turned off or there

is no activity for 60-seconds.

Rapid resume logic

The current state of the alarm will be stored in non-volatile memory. If

power is lost and then reconnected, the system will recall the stored state

from memory (arm, disarm, and Valet mode).

N3001L_2009-04print.qxd 5/12/2009 11:14 AM Page 30

25-Mar-10

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 177 178

Sin comentarios

Directed Electronics Viper ESP 540 Guía de instalación Pagina 36