Directed Electronics PS-3655E-FM Especificaciones descargar pdf (Pagina 65)

DE3

CIRCUIT BREAKERS

01/15

DE3-65

Moulded Case Circuit Breakers

CDP Breaker Cross to Square D

CDP Connector Kits

The CDP connector kits are used to install Square D breakers into existing Federal Pioneer CDP panels and Switchboard distribution interiors that originally

used branch breakers from the Horizon family.

Please note that these connector kits are designed to be applied on CDP interiors with Extruded Bus only, (except HDCMH, JDCMH, and LDCMH that can be

also

used on CDP interiors with Flat Bus).

Please refer to installation bulletins for detailed information on these kits.

Retrofitting or adding new Square D Breakers into CDP Interiors

Federal Pioneer

Horizon Breaker

Amperage Alternate Square D Breaker Connector Mounting Hardware

CE Breaker

15A – 100A 15A – 100A Powerpact H ■ HDCMH

150A – 250A 150A – 225A Powerpact J ■ JDCMH

CJL Breaker 100A – 400A LA/LH ● LACMH

CJM Breaker* 300A – 600A

400A-600A PowerPact L● ❑

LDCMH

CK 250A – 1200A Powerpact P◆ PCDPCMH

■ Need to be replaced in pairs, can not mount a CE breaker back to back with a PowerPact breaker. Not suitable for 100% rated and type HR, JR

MCCBs.

● Available only as single mount option. Not available as a double mount or Back to back mount due to dimensional constraints.

Condition 1: Panel with all single row branch circuits.

A minimum branch circuit height of 8-1/4” is required.

Condition 2: Panel with all double row branch circuits.

This will require a modification to the trim to remove a section of the trim centre strip in the location where the new breaker is to be installed.

A minimum branch circuit height of 9-5/8” is required and the breaker should be located where the centre strip ends. (This space includes

one 1 -3/8” wide filler to suppor t the center strip).

If the breaker must be located between two sections of a double row trim then the minimum branch circuit height required is 11”. (This space

includes two 1-3/8” wide fillers to support both ends of the centre strips)

❑ The PowerPact L-Frame breaker has an overall height of 5-1/2” but will be fitted with a Cover plate to fill the existing branch circuit space of

8-1/4”.

◆ Available only for single mount. The CK breaker can not be replaced in existing 12X of branch circuit height, the Square D PowerPact breaker

requires space with a 16X branch nominal height. Contact Schneider Services for installation of PowerPact P breaker and mounting hardware.

* PowerPact L-Frame can also be used to replace Square D LC/LI/LX/LE/LXI installed in CDP panels as a replacement of CJM breakers.

DE3_p065.fm Page 65 Friday, January 23, 2015 12:24 AM

1 2 ... 60 61 62 63 64 65

Comentarios a estos manuales

Sin comentarios

Directed Electronics PS-3655E-FM Especificaciones Pagina 65

Comentarios a estos manuales

Relacionado con productos y manuales para Arrancadores remotos Directed Electronics PS-3655E-FM