
Perform a Rapid Run
70
Part # 15035786 Rev. D
Introduction
Rapid Run mode provides 2 options for the cluster generation step, either on the cBot or on
the HiSeq 2500. Clustering on the cBot allows 2 libraries, 1 each lane, on the 2-lane rapid
flow cell. After template hybridization and first extension on the cBot, the remainder of the
clustering process is performed on the HiSeq.
After reagent preparation, run setup steps include entering run parameters, loading and
priming reagents, loading the flow cell, and performing a fluidics check. If clustering is
performed on the HiSeq 2500, the step to prime reagents is omitted in the run setup steps.
Visit the HiSeq 2500 specifications page on the Illumina website for information about run
duration and other performance specifications.
Rapid Run Sequencing Consumables
Rapid Run Kit Name Description
HiSeq Rapid SBSKit v2
or
TruSeq Rapid SBS Kit (v1)
Contains SBSreagents used on the HiSeq 2500 and
funnel caps for SBSreagent bottles.
HiSeq Rapid PECluster Kit v2
or
HiSeq Rapid SRCluster Kit v2
or
TruSeq Rapid PE Cluster Kit (v1)
or
TruSeq Rapid SRCluster Kit (v1)
Contains clustering and indexing reagents used on the
HiSeq 2500 and a set of flow cell gaskets.
The PE versions of the cluster kits include paired-end
reagents used on the HiSeq 2500.
Reagent Preparation Steps
Before setting up the run, prepare SBS reagents, indexing reagents, and paired-end reagents.
} For SBS reagent preparation, see the appropriate guide:
• HiSeq Rapid SBSKit v2 Reagent Prep Guide (part # 15058772)
• TruSeq Rapid SBS Kit Reagent Prep Guide (200 Cycles) (part # 15036501)
• TruSeq Rapid SBS Kit Reagent Prep Guide (50 Cycles) (part # 15036502)
} For indexing and paired-end reagent preparation, see the appropriate guide:
• HiSeq Rapid Cluster Kit v2 ReagentPrep Guide (part # 15059131)
Comentarios a estos manuales